David Hempenstall
30-Oct-2003, 14:39
hi,
in a bit of a confused state.
my kodak master camera 8x10 refuses to move the first extension bed any further than 3.5 inches.
i loosen the knob on the right hand side, and the bed moves smoothly, then abruptly stops with a promounced 'impact'.
the only thing i could think that was stopping it was the attachment of the tripod thread in the bed. it is held on with 3 screws which are connected to nuts on the inside. these nuts and the bolt ends are raised. is this normal on the kodak?
i can only look at this arrangement through the hole in the extension. i got my finger in there and loosened the srews down with a small screwdriver so they were flush with the nut, but still only got 3.5 inches of movement.
am i missing something really simple?
the other extension works fine with the tab, locking in all the possitions marked.
cheers,
dave.
in a bit of a confused state.
my kodak master camera 8x10 refuses to move the first extension bed any further than 3.5 inches.
i loosen the knob on the right hand side, and the bed moves smoothly, then abruptly stops with a promounced 'impact'.
the only thing i could think that was stopping it was the attachment of the tripod thread in the bed. it is held on with 3 screws which are connected to nuts on the inside. these nuts and the bolt ends are raised. is this normal on the kodak?
i can only look at this arrangement through the hole in the extension. i got my finger in there and loosened the srews down with a small screwdriver so they were flush with the nut, but still only got 3.5 inches of movement.
am i missing something really simple?
the other extension works fine with the tab, locking in all the possitions marked.
cheers,
dave.