Pentax Spotmeter problem

[Simon Benton]

I have a Honeywell Pentax 1/21 analog spotmeter (with the light switch to illuminate the screen) that is not working properly. In normal light the needle always jumps immediately to the end of the scale - in dim light when I use the low level switch it also jumps immediately to the end of the scale. Is it shot or is there something I can do to correct? Any suggestions gratefully received.

[Collas]

Try a new battery first of all. I found that I was getting strange readings from both the analogue V and the Digital until I put in some fresh batteries.

Nick

[Simon Benton]

Both batteries are new and delivering full voltage according to my meter. Needle jumps to end of scale ar high speed and stays there.

[Marc B.]

Sounds like a call/trip to Quality Light is in order.
Call them to confirm correct/updated mailing address.

Quality Light Metric Co
7095 Hollywood Blvd # 550
Los Angeles, CA 90028-8912
USA
Phone: (323) 467-2265

[Richard Rau]

Richard Ritter also specializes in Pentax Spot Meter repairs.

[ki6mf]

Mine did this from day one. It would then settle down and give accurate readings. I suspect its related to the switch and either of the two repair facilities can fix this if the parts are available.

[bobherbst]

Richard Ritter. I just had him overhaul my Pentax Spotmeter V that was 22 years old and was just plain worn out - something about 20-30,000 uses.... Good as new.

[neil poulsen]

From you description, you might check to see if you're getting the same readings in low right areas with and without pressing the button. If so, it could be just a simple short of the button.