View Full Version : Besseler 23c negative holders
joe rott
13-Oct-2011, 17:11
I recently aquired a besseler 23c enlarger. I didn,t have any negitive holders for it. I don't want to purchase any because I have the materials and tools to make them.I am looking for someone with a 23c that could make a full size template by tracing an outline of a 2 1/4 and a 35mm holder on a sheet of paper and sending it to me. I can send a self addressed stamped enveope.
Thanks for your help
joe rott
jrott37@yahoo.com
Joe,
Where are you located?
PM Sent
Dan
Wayne Aho
13-Oct-2011, 18:23
they are actually fairly cheap on fleabay (avoid the buy-it-now crowd).
joe rott
17-Oct-2011, 17:02
Hi Dan
Thanks for the reply.
I'm located at:
Joe Rott
Fort Wright, KY
Thanks again
Joe,
Might edit that last post to just your 'general location' - most everything here is viewable web-wide...
and another PM sent...
Dan
joe rott
17-Oct-2011, 18:10
DanK
I'm new to posting on forums. What does the term or abbreviaton PM mean & Thanks for the tip about using my address.
Joe
Joe,
PM is Private Message - Upper right hand corner of the page will show if you have any unread messages...
I did get the address, and will scribe the plate and get it in the mail tomorrow.
Cheers,
Dan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.