Scott --
14-Jan-2011, 14:49
Hi, all -
I'm spec'ing new bellows for the Asanuma, and need to figure out maximum draw. As the original bellows are off the camera, I'm not sure how I can accurately measure length on them. Alternatively, I can measure between standards. With both vertical, the draw is 14". But if I apply front forward tilt and rear back tilt, the draw at the center of the two standards becomes 15". Which is right? Is there enough give in a bellows that I can spec it for 14" and still get another inch out of it with movements?
Scott
I'm spec'ing new bellows for the Asanuma, and need to figure out maximum draw. As the original bellows are off the camera, I'm not sure how I can accurately measure length on them. Alternatively, I can measure between standards. With both vertical, the draw is 14". But if I apply front forward tilt and rear back tilt, the draw at the center of the two standards becomes 15". Which is right? Is there enough give in a bellows that I can spec it for 14" and still get another inch out of it with movements?
Scott