Morten
29-Jun-2010, 16:39
Hi,
I have nice 210 / 4.5 Xenar in a barrel, but would like to use it in my #3 shutter (not so often used with the 355/9 G-claron now mounted there).
The front element comes off with no problem, but the rear element is not moving at all.. Any tricks here? (or pin screws I not have seen so far) cooling/heating/spanners/hammers etc..
I'm sure i can get it out with the bigger hammer approch, but it would be dam fine if its usable at the same time also :)
Solved, using my lens spanner... but its much smaller than the #3 shutter!! So more research or a help:new thread. :confused:
Best Regards
Morten
I have nice 210 / 4.5 Xenar in a barrel, but would like to use it in my #3 shutter (not so often used with the 355/9 G-claron now mounted there).
The front element comes off with no problem, but the rear element is not moving at all.. Any tricks here? (or pin screws I not have seen so far) cooling/heating/spanners/hammers etc..
I'm sure i can get it out with the bigger hammer approch, but it would be dam fine if its usable at the same time also :)
Solved, using my lens spanner... but its much smaller than the #3 shutter!! So more research or a help:new thread. :confused:
Best Regards
Morten