Richard Boulware
9-Mar-2002, 21:39
In a post a dozen lines back, Roger Urban asked the question about 'How to proce ss large print murals'.
In the U.S. Navy, years ago, we did this by standard Navy procedure. The Navy had tanks,... we called, 'Elephant tanks', that were about eight inched in diameter, made out of SS. They were 'U' shaped or hemispherical, with welded aquare ends on them. It took two people to process a 40" wide section of mural paper. Under safelights, one technician would hold the scrolled up mural, while the other would take the lip of the paper and start to scroll it into the eleph ant tank full of Dektol. When the entire piece of photo paper was in the Dektol, the first guy would grab the lip of the mural and raise it as high as he could, and the process would be performed again, until development would be completed. Same for the short stop, and hypo, and the forth tank would be the wash. Worked just great, but with working with such large pieces of photo paper, we always m ade sure we had alot of 8X10" test prints from the center of the image to the ed ge of the scene. Working with PVC pipe, it would be easy to make such an 'elephant' tank by takin g some 8" or 10" PVC pipe and sawing it in two. Our tanks were 44" long, to acco modate 40" paper. Used minimal solution...but you have to remember that a 40" X 160" mural, takes a lot of chemicals. Forgot to mention, that if you make one o f these systems, don't forget to use PVC cement, and cement a 10" or 12" square slab of PVC material at each end. Used these techniques, many times. If it works for the U.S.Navy, it will work for you. A reminder that using this technique, i t will be easy to gouge the wet emulsion with your finger nails, so we always us ed rubber gloves for the guy doing the scrolling into the solution. Be well. Richard Boulware - Denver.
In the U.S. Navy, years ago, we did this by standard Navy procedure. The Navy had tanks,... we called, 'Elephant tanks', that were about eight inched in diameter, made out of SS. They were 'U' shaped or hemispherical, with welded aquare ends on them. It took two people to process a 40" wide section of mural paper. Under safelights, one technician would hold the scrolled up mural, while the other would take the lip of the paper and start to scroll it into the eleph ant tank full of Dektol. When the entire piece of photo paper was in the Dektol, the first guy would grab the lip of the mural and raise it as high as he could, and the process would be performed again, until development would be completed. Same for the short stop, and hypo, and the forth tank would be the wash. Worked just great, but with working with such large pieces of photo paper, we always m ade sure we had alot of 8X10" test prints from the center of the image to the ed ge of the scene. Working with PVC pipe, it would be easy to make such an 'elephant' tank by takin g some 8" or 10" PVC pipe and sawing it in two. Our tanks were 44" long, to acco modate 40" paper. Used minimal solution...but you have to remember that a 40" X 160" mural, takes a lot of chemicals. Forgot to mention, that if you make one o f these systems, don't forget to use PVC cement, and cement a 10" or 12" square slab of PVC material at each end. Used these techniques, many times. If it works for the U.S.Navy, it will work for you. A reminder that using this technique, i t will be easy to gouge the wet emulsion with your finger nails, so we always us ed rubber gloves for the guy doing the scrolling into the solution. Be well. Richard Boulware - Denver.