View Full Version : 10x8 & 5x7 in Jobo CPE2+
brighamr
20-Jun-2010, 09:51
Hi
I would like to process 10x8 and also so 5x7 B/W C41 and E6 in a CPE2+
It would seem that the Expert drum will not fit so what should I use
Regards
Robin
My experience so far is :
I did E6 8x10 2 at a time (without lift as well). Failure rate is about 4 out of 16. I suspect one need to use recommended volume (not too much and not too low) and also ensure that the hole is plug (as you are not using the central rod; plug the middle hole is needed if not using the cup).
I am still experiment with 1 for my ATL1500 after the 2 each time of my CPE+. The ATL1500 is 1 at a time and still so far 50% already.
But I did got a Duolab as well as an expert drum (with Cibachromic roller). Would see whether it is better.
Hi
I would like to process 10x8 and also so 5x7 B/W C41 and E6 in a CPE2+
It would seem that the Expert drum will not fit so what should I use
Regards
Robin
Expert-Drums fits on CPP-2, and the ATL's (except ATL1500)
kind regards
Hermann
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.