coops
12-Apr-2010, 06:20
The instructions call for the developer to be mixed with water at 120 degs, and the Blix at 125 degrees. Further down the instruction sheet, it reads "use water at the temperature you want to develop your film". Well I want to develop my film at 90 degs on the Jobo, so this confuses me a little. Can anyone clarify please?
Also, Arista recommends the chemicals be used one shot, but if the developer is used say twice, extend dev. time by 8%. Is this fairly safe, to use developer twice?
It seems the blix may be used over quite safely.
Also, Arista recommends the chemicals be used one shot, but if the developer is used say twice, extend dev. time by 8%. Is this fairly safe, to use developer twice?
It seems the blix may be used over quite safely.