Greg Lawhon
31-Oct-1998, 00:06
I'm mounting a lens to a board for the first time. I understand the instructions , it looks easy, and I've got a spanner wrench to tighten the retaining ring. M y lens has a Copal #0 shutter, and the instructions provide that you can either use or remove the lens alignment pin on the back of the shutter. If used, the p in apparently fits into a small hole drilled in the board to help keep the lens from moving around when mounted in the board.
If I use the pin, I'll probably want to take the board to a shop to get it drill ed in the proper diameter, depth, and place. Do you recommend using the pin, or should I just unscrew it (as the instructions provide if you don't want it) and mount the lens without it?
Thanks for your advice.
If I use the pin, I'll probably want to take the board to a shop to get it drill ed in the proper diameter, depth, and place. Do you recommend using the pin, or should I just unscrew it (as the instructions provide if you don't want it) and mount the lens without it?
Thanks for your advice.