View Full Version : Can this E-6 transparency be recovered
I develop my E-6 in Jobo 3005 drum mostly without any problems. This time I must have had some moisture in one of the drums as the magenta film back layer has not washed off, see attachment.
In B&W this can be cured by placing the negative in the fixer again. How can you cure this E-6 transparency. I am using Tetenal 3-bath process chemicals.
Henry Valtonen, Helsinki
michaelezra
6-Jan-2009, 07:41
I guess, scan and then fix in Photoshop at this point...
Paul Metcalf
6-Jan-2009, 08:59
Soak it in a tray of water would be my guess. I prewash my E-6 prior to development (in Jobo drum) and the rinse water comes out pink/magenta, so I think this is a water soluable coating (for anti-halation purposes).
Yea just re-wash it, it'll be fine
Yea just re-wash it, it'll be fine
Thanks guys, I will give the film another wash and then stabilize.
Thanks
Henry
I immensed the film for 5 min in 38C warm water with NO EFFECT.
The anti-halation layer is now "fixed" and needs the right chemical treatment.
Thanks for any help?
Bruce Watson
6-Jan-2009, 11:23
I immensed the film for 5 min in 38C warm water with NO EFFECT.
The anti-halation layer is now "fixed" and needs the right chemical treatment.
Thanks for any help?
Might want to ask this same question in the Color: Film, Paper, and Chemistry (http://www.apug.org/forums/forum40/) forum over at APUG. APUG has a couple of the retired Kodak engineers as members. Maybe one of them will have an answer for you.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.