View Full Version : Jobo CPA-2 fuse problem
argos33
28-Dec-2008, 20:50
I have a Jobo CPA that keeps blowing the fuse to the motor. No matter what fuse I put in it, it blows within minutes. I have looked over the circuits and don't see any places where it is shorting out. The pump and temperature features still work, just not the motor. It is a pretty big pain to take the thing apart each time to change the fuse so I have given up on it, but if anyone has any suggestions for fixing it I would be eternally grateful.
Evan
ic-racer
28-Dec-2008, 23:25
Would it be possible to post the schematic?
Greetings,
If you are using Expert Drums, this may apply. I don't know if it's still possible to get the upgrade though.
http://www.jobo.com/jobo_service_analog/us_analog/bulletins/b019.htm
Good Luck!
George W.
29-Dec-2008, 12:44
I do not know the CPA, just wondering whether they have a similar EFI capacitor installed?
http://www.apug.org/forums/forum43/56152-smoking-jobo-atl-2300-a.html
How many different fuses are in the CPA?
Brandon Draper
29-Dec-2008, 13:27
Thanks for the info. I will have to go check my CPA to see which one I have.
argos33
29-Dec-2008, 23:23
Thanks for the suggestions, I think there are two: one main (for pump, heater) another for the motor. I should add that when I first got it, it was working fine. Then on the second run it blew the fuse on the wash cycle. I replaced the fuse once or twice after that and each time it blew within 30 seconds to 2 minutes (with no tank).
Evan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.