View Full Version : Korona 8x10 stabilizing bars
Darren Kruger
11-Jun-2008, 11:35
Does anyone have some tabilizing bars for a 8x10 Korona that they could measure for me? I'm looking for general length, width, and height. I'm thinking of making some for my camera.
-Darren
kenkuro
11-Jun-2008, 15:35
3/4" wide, 1/2" high, 14" long.
The height starts to taper down at 3 inches from both ends to 5/16"
As is, it is not much of a stabilizer. If I were you, I would make at least 1" high and
24" long, providing the weight and bulk is not an issue.
- Ken
Jim Noel
11-Jun-2008, 18:17
Ken,
My original stabilizers which measure the same as yours do a terrific job. If made of a good hardwood there is no need for them to be any larger.
Darren,
If you still need more info after I return from a photo expedition in about two weeks, let me know and I will make even more precise measurements of mine.
Jim
Darren Kruger
11-Jun-2008, 19:02
If you still need more info after I return from a photo expedition in about two weeks, let me know and I will make even more precise measurements of mine.
I should be fine with Ken's measurements (Thanks Ken!) I just wanted ballpark numbers so I could get the same functionality while looking somewhat like they belong with the camera.
-Darren
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.