m.bruehl
1-May-2008, 05:25
Hi,
I did some searching in older threads, but I don't feel sure because different expressions are used for parts.
As far as I know the rear standart on P as well as P2 consists of three main parts:
part 1: the block with moving mechanisms, directly on the rail: "rail carrier"
part 2: the frame that is connected to the carrier, available for 4x5, 5x7 or 8x10: "bearer"
part 3: the frame with groundglass where I put my film holder into: "frame" or "measurement frame"
(Please correct me if I'm wrong with the naming)
My questions:
Does a P2 bearer (part 2) connect to a P rail carrier (part 1)?
Does a P2 measurement frame (part 3) connect to a P bearer (part 2)?
Are the bellows for P and P2 bearers compatible?
Thanks in advance
Mike
I did some searching in older threads, but I don't feel sure because different expressions are used for parts.
As far as I know the rear standart on P as well as P2 consists of three main parts:
part 1: the block with moving mechanisms, directly on the rail: "rail carrier"
part 2: the frame that is connected to the carrier, available for 4x5, 5x7 or 8x10: "bearer"
part 3: the frame with groundglass where I put my film holder into: "frame" or "measurement frame"
(Please correct me if I'm wrong with the naming)
My questions:
Does a P2 bearer (part 2) connect to a P rail carrier (part 1)?
Does a P2 measurement frame (part 3) connect to a P bearer (part 2)?
Are the bellows for P and P2 bearers compatible?
Thanks in advance
Mike