View Full Version : Jobo CPA-2 with CPE-2 lift???????
I have recently acquired a jobo cpa-2 processor with a cpe-2 lift attached....... will this work? I obviously could just try it, but was curious as to whether anyone here would know. Thanks.
Jordan
Erik Larsen
9-Apr-2008, 14:33
It might work:) There may be the downside that it won't work with the expert drums. Honestly, I don't know. I have a cpe2 and can't use expert drums and I'm not sure if it is because of a smaller motor or if the lift mechanism can't handle it.
give it a shot
Erik
....I have a cpe2 and can't use expert drums and I'm not sure if it is because of a smaller motor or if the lift mechanism can't handle it.
Erik
The expert drums just plain don't fit. The diameter is too big to fit in the CPE-2. It is close but, still too big.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.