chy
8-Mar-2008, 17:29
Since there is quite a bit of interest in the Combi Plan tank, I looked for my original instruction sheet and the notes I wrote on it. Here are the developing times of some film and developer combinations I used and hopefully it can help someone as a starting point.
Please don't take it as gospel, it worked for me for a long time and it might or might not work for you as my films, developers and processing times are from the previous century :) Maybe the goodies in the water are different nowadays! I did fine tune developing times depending on subjects and exposures, so your times might very well be different from mine.
=====================
Fill time - +/- 30 secs.
Drain time - +/- 30 secs.
1200ml of solution
I've always used a water pre-wet - 1 min. and an inversion or two, not critical. Use the same temperature as the intended developer.
General agitation pattern - Continuous inversions first 30 secs., then 2 inversions every 15 secs.
======================
KODAK PLUS-X
D-76, 1:1 dilution - 8 mins. @ 70 deg.F
HC-110, 1:31 dilution - 6.5 mins. @ 68 deg.F
Sprint Standard, 1:9 dilution - 10 mins. @ 68 deg.F
======================
KODAK T-MAX100
HC-110, 1:31 dilution - 7.5 mins.
(agitation is continuous first 30 sec., then 6 inversions every 15 secs.
Hope this helps, good luck!
Please don't take it as gospel, it worked for me for a long time and it might or might not work for you as my films, developers and processing times are from the previous century :) Maybe the goodies in the water are different nowadays! I did fine tune developing times depending on subjects and exposures, so your times might very well be different from mine.
=====================
Fill time - +/- 30 secs.
Drain time - +/- 30 secs.
1200ml of solution
I've always used a water pre-wet - 1 min. and an inversion or two, not critical. Use the same temperature as the intended developer.
General agitation pattern - Continuous inversions first 30 secs., then 2 inversions every 15 secs.
======================
KODAK PLUS-X
D-76, 1:1 dilution - 8 mins. @ 70 deg.F
HC-110, 1:31 dilution - 6.5 mins. @ 68 deg.F
Sprint Standard, 1:9 dilution - 10 mins. @ 68 deg.F
======================
KODAK T-MAX100
HC-110, 1:31 dilution - 7.5 mins.
(agitation is continuous first 30 sec., then 6 inversions every 15 secs.
Hope this helps, good luck!