View Full Version : Durst 138s condensers ?
Brad Bireley
1-Jun-2007, 18:28
I picked up my Durst 138s yesterday. One of the condenser lenses has shifted. Does anyone know what type of wrench I need to loosen the nuts to move the glass back to the correct position?
Thanks in advance,
Brad
big_ben_blue
2-Jun-2007, 08:10
I assume you are talking of the nuts and bolts holding the casing together, right? The nuts are metric, about an M4 size. A small #7 socket does work, but most likely you will have to grind the outside of the socket down to a thinner wall size to make them fit into the holes (a real pain to do; I used a Dremel to do that). Also keep in mind,that the lens assembly is held in place by springloaded clamps under quite some pressure.
Brad Bireley
2-Jun-2007, 09:34
Yes, the nuts holding the casing together is what I'm talking about.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.