sheldon hambrick
25-Jun-1998, 12:57
I'm in the process of referbusing an old Crown Graphic. The bellows has some ho les that were previously repaired. Whoever made this repair did a pretty good j ob on the inside of the bellows, but used good ol silver duct tape on the outsid e.
I'd like to know what would be the best material to use to re-patch the outside of the bellows. While thinking about it, I figured that I could cut the same se ction from an junker Graphic (or similar sized bellows) and overlay it. Any ide as, suggestions?
Thanks
I'd like to know what would be the best material to use to re-patch the outside of the bellows. While thinking about it, I figured that I could cut the same se ction from an junker Graphic (or similar sized bellows) and overlay it. Any ide as, suggestions?
Thanks