Jean Nightingale
1-Apr-2007, 09:29
Hello All
I've been using my Paterson Orbital Print Processor to do single 5x4 negs. Been using ID11 at stock solution Normal 7.5 minutes with intermitent agitation 15secs every min. Ive not been aware of any developing streaks until I put 4 negs in to do a film speed test. (thinking this would be a good way of keeping everything consistant.) Being blank negs the streak marks become very obvious. So bad the test was useless.The runners on the underside of the lid cause streaks right down the negs. I was wondering whether anyone here uses one of these tanks and could give some advice on how they use them. Can you only develop one at a time? Or do you have to have it on a motorised base or give constant agitation?
Any other tips appreiciated.
JNight
I've been using my Paterson Orbital Print Processor to do single 5x4 negs. Been using ID11 at stock solution Normal 7.5 minutes with intermitent agitation 15secs every min. Ive not been aware of any developing streaks until I put 4 negs in to do a film speed test. (thinking this would be a good way of keeping everything consistant.) Being blank negs the streak marks become very obvious. So bad the test was useless.The runners on the underside of the lid cause streaks right down the negs. I was wondering whether anyone here uses one of these tanks and could give some advice on how they use them. Can you only develop one at a time? Or do you have to have it on a motorised base or give constant agitation?
Any other tips appreiciated.
JNight