GhoSStrider
18-Mar-2023, 13:55
Hello All,
I recently picked up a new set of bellows for my Kodak 2-D with the frames already installed. Getting the old bellows off of the front standard was a simple matter of removing 9 screws. However, I can’t figure out how the bellows attach to the rear standard. I see a number of tacks in the frame but was assuming that these were just to hold the fabric to the frame? Or do I need to remove each and every one of these tacks to remove the frame from the standard.
Thank you in advance for any assistance!
Chris
West Chicago, IL
I recently picked up a new set of bellows for my Kodak 2-D with the frames already installed. Getting the old bellows off of the front standard was a simple matter of removing 9 screws. However, I can’t figure out how the bellows attach to the rear standard. I see a number of tacks in the frame but was assuming that these were just to hold the fabric to the frame? Or do I need to remove each and every one of these tacks to remove the frame from the standard.
Thank you in advance for any assistance!
Chris
West Chicago, IL