Fatih
10-Feb-2022, 06:25
Hi all,
I have acquired a 2nd hand Nova FB processor which came with 8x10 and 16x20 FB Print holders. Then I went ahead and have purchased a separate Nova Agitation Clip, as I am printing RC as well, however I am not happy with the design of it. It looks like the clip holds the paper by 2 needles which will eventually make 2 holes on the print. Also for test prints etc, I don't have smaller clips to hold test strips or sizes between 8x10 and 16x20.
So my question is, does anybody use any other more practical holder with their processors? Any advice on this will be greatly appreciated.
Many thanks,
Fatih
I have acquired a 2nd hand Nova FB processor which came with 8x10 and 16x20 FB Print holders. Then I went ahead and have purchased a separate Nova Agitation Clip, as I am printing RC as well, however I am not happy with the design of it. It looks like the clip holds the paper by 2 needles which will eventually make 2 holes on the print. Also for test prints etc, I don't have smaller clips to hold test strips or sizes between 8x10 and 16x20.
So my question is, does anybody use any other more practical holder with their processors? Any advice on this will be greatly appreciated.
Many thanks,
Fatih