PDA

View Full Version : Can I attach JOBO lift #4072 to CPE2-Plus?



Chan
8-Feb-2006, 17:39
Hi folks,

I'm an JOBO CPE2-Plus user and considering to buy a JOBO lift #4072, not #4062.

I wonder whether I can attach lift #4072 to my CPE2.

If you have an information, please share your tip.

Thanks in advance.

Chan

Eduardo Aigner
8-Feb-2006, 18:39
From the Jobo "new" site:

The JOBO Lift Accessory is an item you can add to your CPE-2 Plus (Lift #4062), CPA-2, or CPP-2 processors (Lift #4072 for either). It allows you to dump and fill the chemicals easier than doing it by hand. Also, when you use the Lift, the chemicals are introduced to the film in a more consistent manner which will help your processing run-to-run.

http://www.jobousadarkroom.com/products/lift.htm

Oren Grad
8-Feb-2006, 19:02
I think that the CPE and CPA/CPP lifts are not interchangeable. In other words, you need the 4062.

Jeff Moore
9-Feb-2006, 00:27
I guess you didn't like the answer I gave you to this question on the photo.net site. Alas, it looks like you got the same answer here.

arichard
18-May-2015, 09:28
I guess you didn't like the answer I gave you to this question on the photo.net site. Alas, it looks like you got the same answer here.

Hello, I have a similar problem ... I have a CPE2+ processor and a Lift #4072.

With some adaptations, would it be possible to adapt it to a CPE2+ processor?

Regards

koh303
18-May-2015, 10:12
Hello, I have a similar problem ... I have a CPE2+ processor and a Lift #4072.

With some adaptations, would it be possible to adapt it to a CPE2+ processor?

Regards

No.
You will need to:
1. get a base plate for the CPE2
2. Modify the lift to be able to use it with the baseplate.

The parts are in stock.