IanBarber
24-Oct-2020, 13:34
I was recently given some old remnants from an old darkroom and in the box was an RH Design Zone Master II.
Today, I started to look at it and see what it can do and after spending an hour or so studying the manual I gave it a go on some Ilford MG IV paper.
To be honest, I was very impressed with the results after just making 2 measurements as indicated in the manual.
Question:
I have no MGIV paper left now and the next purchase is going to MG V and according to the manual, the calibration for the ZomeMaster II is for MV IV. I know you can re calibrate it for any paper but the process is beyond my darkroom experience.
Has anyone already calibrated this device for Ilford MG V and if so are they willing to share the numbers so I can push them into this device I have.
Ian
Today, I started to look at it and see what it can do and after spending an hour or so studying the manual I gave it a go on some Ilford MG IV paper.
To be honest, I was very impressed with the results after just making 2 measurements as indicated in the manual.
Question:
I have no MGIV paper left now and the next purchase is going to MG V and according to the manual, the calibration for the ZomeMaster II is for MV IV. I know you can re calibrate it for any paper but the process is beyond my darkroom experience.
Has anyone already calibrated this device for Ilford MG V and if so are they willing to share the numbers so I can push them into this device I have.
Ian