streaks in Imacon scans

[Tyler Boley]

I have a friend with a Flextight Precision ll, he has intermittent subtle streaks, much like something I might get with a bad bulb in my drum scanner, or a dirty calibration area in a flatbed. Any advice appreciated.
Tyler
186282

[bob carnie]

Tyler - looks like a film problem to me , neutral backgrounds can be impossible Minus Density and Plus Density issues.
I have a flextight and Creo and have never seen this type of issue. Has your friend tried to recalibrate the machine for focus issues, there may be some hesitation on the rollers, the Flextight is a pretty simple and rugged design. Hassalblad I believe is in Vancouver and they do fix the machines.

[cdavis324]

A lot of times its dust on the condenser. Have him clean the bottom part when the lamp is and see if it gets rid of/moves the stripe!

Sent from my LM-V350 using Tapatalk

[Tyler Boley]

thank you both, I've passed the info on and we'll see where it goes. They did inform him they no longer service that model.

[bob carnie]

thank you both, I've passed the info on and we'll see where it goes. They did inform him they no longer service that model.

Omer Hecht in Boston is really resourceful and runs Cat Labs, I know he has had a lot of experience with Imocans. I would have your friend check with him.

[norly]

Hello.
I had similar problems with my Imacon 949. Se attached image.

I tried to get it serviced locally, but he never managed to find the problem, or solve it. (It was only visible 4x5s). So I sent it of to hasselblad for a proper service. They said it was due to bad crystals. You can also see it on the histogram from the developer menu.

187351187352

It all went under as normal service. Now it works!

187353

Super scanner by the way. Been using it professionally for the last 10 years. I used to have a flextight, but the 949 is just much much faster! Kind of same quality, but saves a bunch of time.

[Richard Wasserman]

You might contact B23 Hasselblad Repair in Copenhagen. They are an authorized repair center for Imacon scanners and have parts for older scanners. I needed a new motherboard for my Flextight III and Jimmy Bjaaland was able to help me with diagnosing and solving the trouble I was having. He is at: Hasselbladrepair.com
Good luck!

[Tim V]

Definitely either dust on or under the condenser, or fauly CCD / circutry. My 949 was recently serviced for the same issue and had the CCD replace, now it's perfect again. The problem only showed up with 120 and 4x5" for me.

[bob carnie]

Definitely either dust on or under the condenser, or fauly CCD / circutry. My 949 was recently serviced for the same issue and had the CCD replace, now it's perfect again. The problem only showed up with 120 and 4x5" for me.

Tim where did you have your Scanner serviced??

[Tim V]

CR Kennedy, Australia (via Auckland, New Zealand.)

[bob carnie]

CR Kennedy, Australia (via Auckland, New Zealand.)

thanks Tim quite a road trip for my Imocan