g claron 150 in prontor svs?

[chris77]

hello.
i have a g claron 150 in barrel and want to mount the lens cells.
its obviously a copal 0 fit. it does also fit in the prontor svs i have here, but i am wondering if the spacing would be correct? the thread of the prontor seems deeper(longer) than on the synchro compur...
tx for info

[Dan Fromm]

The cells should be a direct fit. But and however, if you're not sure, measure the lens' length -- front edge of front cell-to-rear edge of rear cell -- in its barrel and with the cells screwed into the shutter. Then you'll know for sure.

[Jim Galli]

Measure them in the barrel with a caliper, then put them in the Prontor and measure again. Far more accurate than asking the blokes here. Then you can tell us. I put several in Prontor shutters that used to come in Tektronix oscilloscope cameras and they worked perfect.

[chris77]

of course! thanks for pointing it out!!
chris

[chris77]

short answer: no. its not the right shutter for the lens. synchro compur/copal 0 is a perfect match.
chris