Flange for Goerz Syntor f6.8 210mm

[Ron (Netherlands)]

Long time I've searched for a flange for the Syntor f6.8 210mm brass lens, but never found one. The flange should have a 46mm diameter. Anyhow, I might have someone to make one, and I found this - what seems - Spanish company which makes flanges and other camera products. Anyone here who has experience with this company?
http://www.wetplatewagon.com/project/brass-lens-flanges/

thanks
Ron

[Chauncey Walden]

A tight screw in fit hole in the board with a little hot glue on the inside will hold even a heavy Syntor.

[Steven Tribe]

You might widen the search to include all Goetz 210mm F.6.8 lenses. I bet they will fit too. Syntor was a minor variety of Goetz's production.

[Ron (Netherlands)]

A tight screw in fit hole in the board with a little hot glue on the inside will hold even a heavy Syntor.

You might widen the search to include all Goetz 210mm F.6.8 lenses. I bet they will fit too. Syntor was a minor variety of Goetz's production.

Thanks both. Will have a try

[Jac@stafford.net]

Measure carefully if you can, and visit here (https://www.thorlabs.com/newgrouppage9.cfm?objectgroup_id=1535).

[Ron (Netherlands)]

Measure carefully if you can, and visit here (https://www.thorlabs.com/newgrouppage9.cfm?objectgroup_id=1535).

Thank you Jac; apparently they make retaining or locking rings, but no flanges or mounting rings (https://picclick.com/?q=brass+lens+flange).