linhof #73385 - They are missing some pieces or some are broken

[Ricardo Maydana]

Hi all, I just take a technika IV (I think that's the model # 73385). They are missing some pieces or some are broken. If anyone has information about this part or a good way to get, I'd appreciate it, thanks! \
parts are a screw
closing the front cover
and obstacles of traseraa
attached photos

Hola a todos, Acabo de tomar una technika IV (creo que ese es el modelo # 73385). Faltan algunas piezas o algunas estan rotas. Si alguien tiene información sobre esta parte o una buena manera de conseguir, se lo agradecería, gracias! \
1-un tornillo faltante
2- el cierre de la tapa frontal
3- y las trabas de traseraa

adjunto fotos
151534

151535

151533

[Bob Salomon]

73385 is the serial number, not the model number. It is a Linhof Super Technika IV from about 1961 or 62. Most of these parts are no longer available from the factory, for instance, you must replace both of the spring arms on the back as the arms made in the last 40 years have a different spring and both springs must match. You can probably find the required parts from Bob at Precision Camera in Niles IL or Rim at Nippon Camera in NY City.

[Ricardo Maydana]

Bob, thanks, would be helpful if someone can confirm whether it is possible to buy internt. I live in Paraguay.
The cost of sending a team to repair is very high as well as the equipment itself.
from already thank you very much for the valuable contribution.
Ricardo

[Bob Salomon]

Bob, thanks, would be helpful if someone can confirm whether it is possible to buy internt. I live in Paraguay.
The cost of sending a team to repair is very high as well as the equipment itself.
from already thank you very much for the valuable contribution.
Ricardo

Just contact them and ask.

[Cor]

Ricardo,

On your first photo: you are indeed missing a screw there, that screw is there so you would not pull out the whole back, but if the screws on the other three rods are ther I would not worry, you could take out one of those screws an go to a hard ware store, see if they have a replacement.

Cannot help you on the second photo, but isn't the closing mechanism on the door, not on the top ?

On the back: try your luck on eBay, or put out a wanted add on this forum: I know from experience that a back on of a TechIII fits perfectly on a TechIV.

or the springs can be put back behind the lever ? Make some more photographs of the back, perhaps we can help,

good luck,

Cor

[Jac@stafford.net]

To clarify the back lock. Do you have the sliding lock - the part marked 'off' in red below?

151591

[Ricardo Maydana]

Cor, thanks for the tips.

on the screws, the rest (three) are fine. is true only have to be careful with subsequent movements.

Photo lid closure, I'll take another photo for better understanding.

On the BACK, I see taking other images for better understanding and thus can help

Thanks for your tips

[Ricardo Maydana]

To clarify the back lock. Do you have the sliding lock - the part marked 'off' in red below?

151591

hello, the part that is broken is the tip that makes entry lever when the film holder.

I see take another picture for better understanding.

Thanks for the tips and contributions

[Jac@stafford.net]

Ricardo, I will look through the spares this evening.

EDIT: I looked and I have not found the arm you need. I have the sliding latch, fasteners and four corner parts to hold the rotating back, but not the part you require. So sorry.
.