View Full Version : MasterView Lens Boards
Steve_571
20-Aug-1999, 21:18
I recently purchased a Kodak Master View (8x10) and am in need of some lens boar ds. I need to mount some lenses (Ilex #5). I also wish to make one board into an adaptor board (for Canham lens board).
A good high quality reproduction is acceptable.
Any ideas or suggestions???
Regards, Steve
John Hicks
20-Aug-1999, 23:25
Check with local machine shops; often they'll make a drill aluminum boards for l ost cheaper than you can buy them from camera dealers.
Sean Billy Bob Boy yates
21-Aug-1999, 01:39
Henry! Henry Stanley! Call for Mr. Henry Stanley!
Sean Billy Bob Boy yates
21-Aug-1999, 01:43
p.s. Al Bowker is at 303 - 650-1984
Steve_571
24-Aug-1999, 12:30
Thank you all... I have contacted Al, and I have two boards on the way!
Steve
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.