koh303
28-May-2014, 12:58
I am working on a very old, and poorly stored V8 camera.
Most of the screws are rusted through...
I have taken the camera apart, but have a hard time understanding how to remove the rear standard stay screws.
This is the screw which goes through the center of each side of the rear standard, and has a locking nut which locks down the tilt of the standard on the tilt braces.
I understand there is a safety to prevent the nut from coming loose and getting lost, but for the life of me cannot figure out how to get it off so i can get the whole thing apart...?
Anyone?
Most of the screws are rusted through...
I have taken the camera apart, but have a hard time understanding how to remove the rear standard stay screws.
This is the screw which goes through the center of each side of the rear standard, and has a locking nut which locks down the tilt of the standard on the tilt braces.
I understand there is a safety to prevent the nut from coming loose and getting lost, but for the life of me cannot figure out how to get it off so i can get the whole thing apart...?
Anyone?