View Full Version : Kodak 2D Back
Does anyone know an 8x10 back from a Kodak 2D or similar camera would fit a Seneca/National. Looking at photos it seem as if it would. I've attached a photo of my current back (minus ground glass) and camera rear. If so, my next question will be posted in the FS/WTB Forum. Thanks in advance for any advice/suggestions.
Measure and post all dimensions. Some of these type backs do interchange and some can be easily adapted.
I have an Eastman back fitting exactly on an Ansco studio and I bought it by dimensions.
Pin distances in all dimensions.
Rebate edges.
OD and light trap ID.
Measure and post all dimensions. Some of these type backs do interchange and some can be easily adapted.
I have an Eastman back fitting exactly on an Ansco studio and I bought it by dimensions.
Pin distances in all dimensions.
Rebate edges.
OD and light trap ID.
Thanks Randy, will do.
So, here are the measurements as close as I could get them. 113282113284
Jon Shiu
4-Apr-2014, 09:32
Hi, the 2D back is about 11-1/2" to 11-9/16" and inset part is 11".
Jon
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.