Jim C.
14-Nov-2013, 19:18
I purchased a Omega D2 enlarger with a variable condenser head
that was deal too good to pass up for my bourgeoning darkroom.
Lots of dust to blow out but I'd like to clean the heat sink/lamp housing
since there's lots of dust in there.
Two molded plastic caps hold the two halves of the cast aluminum
heat sink around the lamp dome, easy peasy to take off.
One 8-32 bolt holds the cap over the wiring and I assume also holds the
lamp socket in place....
But how the heck do you take the ceramic socket out ?
It looks like there's a collar that screws off the ceramic socket,
am I missing something or suddenly became a 98 Lb weaking ?
104598
104599
that was deal too good to pass up for my bourgeoning darkroom.
Lots of dust to blow out but I'd like to clean the heat sink/lamp housing
since there's lots of dust in there.
Two molded plastic caps hold the two halves of the cast aluminum
heat sink around the lamp dome, easy peasy to take off.
One 8-32 bolt holds the cap over the wiring and I assume also holds the
lamp socket in place....
But how the heck do you take the ceramic socket out ?
It looks like there's a collar that screws off the ceramic socket,
am I missing something or suddenly became a 98 Lb weaking ?
104598
104599