Louis Pacilla
9-Jun-2013, 09:24
Just wondering if anyone has come across a stand like this? I'm not much of a metal single post studio stand but when I saw this I just feel in love with it.
The base is one piece iron casting the center post base is aluminum and the three sections are threaded stainless very thick tubing/pipe, the nuts used for raising and lowering each section are aluminum w/ a thick masonite/fiberglass? washer and a locking screw for each section. The horizontal arm is a steel octagon tube and it has two camera platforms which move on sets of wheels built into each platform. All other parts are aluminum/brass. The max elevation is about 7 feet and the lowest position is about a foot and a half.
It has a raised set of numbers in the base casting but that's the only marking on the stand. It sure seems like a lot of work to have manufactured only this one particularly with the cast base with numbers which would seem to have little use for much else.
Anyhow here it is. Let me know if you have seen one before or have any info.
The base is one piece iron casting the center post base is aluminum and the three sections are threaded stainless very thick tubing/pipe, the nuts used for raising and lowering each section are aluminum w/ a thick masonite/fiberglass? washer and a locking screw for each section. The horizontal arm is a steel octagon tube and it has two camera platforms which move on sets of wheels built into each platform. All other parts are aluminum/brass. The max elevation is about 7 feet and the lowest position is about a foot and a half.
It has a raised set of numbers in the base casting but that's the only marking on the stand. It sure seems like a lot of work to have manufactured only this one particularly with the cast base with numbers which would seem to have little use for much else.
Anyhow here it is. Let me know if you have seen one before or have any info.