Hi Folks,
I'm new to LF and have been practising loading/unloading film holders with an exposed sheet of film. I have been following advice from video's on you tube and internet guides (e.g http://www.butzi.net/articles/filmload.htm) and have a few questions:
1) I find that by holding the film along the long edges and slotting into the holder, it is curving slightly. Is this problematic?
2) When you insert the film, do you push it all the way or do you pull it back to the square indent?
3) I will not go through a whole box of film in one go, so need to able to transfer exposed film to another box. I guess the best thing would be to use an old film box, but because I am new to this I don't have any! So, where do you get them from?
4) I plan on sending off film to a lab. As long as it is all, say, negative film does it matter if I mix up films in the same box?
Thanks in advance
Graham
Bookmarks