Hi all,
I realize this is not a computer forum and there are other places I could post this question, but I really like LFPF and there are a lot of people here who know a lot more about this stuff than me.
So here is my issue. I recently got a new workstation (PC, running Windows 7 Pro 64bit), and to help get me set up I also purchased four 3TB Seagate bare drives from Newegg to upgrade my backup system. I use them with drive docks from OWC, usually connected to USB3.
After some trial and error, I realized that I needed to Initalize these as GPT (as this seems better for large disks), and it seemed like a good idea to do a full format (vs. Quick Format) at least the first time they are formated. And I also found that I needed to get Teracopy, as Windows doesnt like copying large amounts of data (annoying, especially coming from Mac).
So I was able to format three of the four drives just fine and copy data to them. However, the 4th drive lets me Initialize it, and allows me to Quick Format it using Computer Managment/Disk Managment. But whenever I attempt to do a Full Format it stops at something like, 41%, 36%, or 34%. The progress just stops there and sits for many hours without doing anything. I know that a full format of a 3TB disk will take a long time, but it seems to usually progress at about 1%/min or so, and once this disk gets to 34% or so it just stops.
It does seem to work fine if I just do a Quick Format, I can copy data to it, but since a Full Format worked on the others I would like to do the same to this drive. It will be my Offsite back-up of all my film scans and print files from 120, 4x5, and 8x10, so I really want to be confident that it is working properly.
Could this be an issue with the actual disk? Should I try exchanging it? Or is it more likely a Windows issue? I have tried 2 drive docks, both on USB3 but tried several different ports on my workstation all with the same result.
Any advice is greatly apprecitated.
Thanks,
Adam
Bookmarks