Is this what I should expect from a Packard shutter on time/bulb?
The picture is from Packard's web site.
I contacted Reno to see if this is correct operation.
He said that he repairs them, so doesn't give advice.
I figure I should find out if it's working as intended before I pay to be told it was OK to start out with.
I'm hoping to be able to get time/bulb to give me the full (in this case 3 1/2") round opening that the shutter looks like ti could do.
The shutter is a #8. (two pistons)
I've searched, but found no answer to this question.
Short version: Is the pie wedge shaped opening what I should expect from a Packard shutter, or can I get it to open up all the way round?