foam brush? How to clean?

[Nasser]

This is my first time to use a foam brush to coat a carbon tissue with Ammonium dichromate... How do I clean the brush afterword? should I just wash it with water?
Thank you in advance
Nasser

[Erik Larsen]

Yeah, just rinse it out with water and only use it for coating tissue so you don't contaminate anything else.
Regards
Erik

[Nasser]

Thanks Erik!

[BrianShaw]

I've thouroughly rinsed and re-used (as Erik said... using only for the same process) but for me they are so inexpensive and easy to get that I just throw them out.

[mdm]

Maybe you dont print much, I would go through tons of them, literally.

[BrianShaw]

That is very true, David. I don't print much so using one for a session and throwing away is not a problem for me. I wish I could print more, but...

[Jay DeFehr]

Maybe you dont print much, I would go through tons of them, literally.

Literally? I sincerely doubt that.

[Erik Larsen]

I've used the same one for years