I've been trying out a recently purchased box of Foma 100 4x5 from Freestyle and have been getting these small specks; white on the print, black on the neg). It seems to happen most strongly in the black areas. I've attached a sample of the last test shot, which I finished with a careful wash in distilled water. In a prior run, I happened to have Delta 100 in the same developing tank with the foma and no spots showed up on those negs, so I'm thinking its associated with the Foma film only and not my procedures. Using PMK in a Jobo 3010. Is it me, or a bad batch of film?