Crossovers are a pain. I was just playing around with someone's image the other day that had that very issue. I think the thing that worked best was going into the hue & saturation adjustment layer and selectively adjusting hue on one color. I was probably in LAB mode.
This post is a bit old but I was printing Kodak Ektar and Portra 160 (4x5) last year using the RA4 processor and scanning with an Epson V700 and noticed a red or magenta color cast sometimes . Once it was there I would not totally go away in the Ra4 process and difficult to deal with when scanning. In my opinion it happened during film processing as the lab I was using only runs film 2/month. I started using a lab with better quality control and those issues went away. It is also possible that there is something wrong with the film.
Don't blame the film. The quality control on these products is superb. Look elsewhere.
Posting Permissions
Reply With Quote
Bookmarks