unicolor print drum use question

[rich caramadre]

If you use a print drum and a roller base to process sheet film, how do you keep the developer temp. consistent ?

[Jim Noel]

Temperature control when processing in a tube has never been a problem for me. The plastic from which the tubes are made does not transfer heat very effectively therefore the temperature of the solutions vary very little if at all.

[jcoldslabs]

Ditto, but I am less of a stickler for temperature consistency than most.

Jonathan

[SMBooth]

Unless the room temperature is at a extreme to 20degC there is not much change over the development time