So I picked up a large process camera with which I'm hoping to make 20x24" wet/dry plate photos. Figured it was LOT cheaper than a custom order, but its going to take some work to get it to work, especially with a back and a plateholder. I am thinking, based on the images of the back, to simply order a back from one of the camera makers, and also use their plateholder. I think adapting the back to the camera won't be anywhere nearly as hard as making my own back/plateholder.
I stil have to figure out how to put this camera on a stand of some sort. I was thinking putting it on a board set up on two Sanford & Davis Airlift tripods
Bookmarks