Building an archival print washer

[Mako]

Comrade silver printers,

Has any one of the learned members of this smashing forum built an archival prin t washer himself? Being totally disappointed by my Paterson print washer I have been thinking about moving on to a better model, if it weren't for the excorbita nt prices.

If someone has a rudimentary plan for this I would appreciate a reply.

Thanks

[David Richhart]

Hi Mako...Somewhere in the archive of this website there is a web address that leads you to the plans for constructing a negative/print washer.

[Jim Chinn]

There is a site called Darkroomsource.com that has a number of articles dealing with construction of darkroom equipment and I believe there are plans for a washer somewhere there.

[Pat Kearns]

I believe that Calumet has cut the prices on archival print washers. I don't want to burst your bubble but by the time you factor in the cost of the plexi-glass, construction time, and aggrevation... it may be easier to call them and say charge it. If you are good with your hands have fun and good luck. Pat.

[Howard Anderson]

What don't you like about the Paterson?

[Mako]

Thank you all.

To Howard: Many years ago I bought a Paterson archival print washer for 30x40 cm paper. However, the chaps in the UK did not take into account that fiber based paper expands quite a bit when wet. This meant that I have to trim each and every sheet of paper before I insert it into the washer. Other manufacturers take account of that but are also about thrice as expensive. So really the Paterson is for 38.5x29 cm paper.

[Russell]

Before building check out the washers available at Versalab.com. Much cheaper than any others I've found. I have been considering attempting to build a washer but I'm concerned both about the cost of materials (plexiglass isn't cheap and I've not found a satisfactory alternative) and being able to establish an effective water flow with my own design. Let me know how you fare. Russell

[Doug Paramore]

Mako: I bought the Versalab washer about four years ago and have found it to be a great washer. The thing is indestructable and will do a bunch of prints at one time. I think at the time I bought mine it was less than $200. I was considering builing one until I ran across a writeup on the Versalab. As stated earlier, by the time you buy plexiglas, cement, hoses, etc., you won't save much if any by building it yourself. Especially if you have to rent or buy the needed tools.

Regards,

[David Karp]

I also have a Versalab print washer and am very happy with it.

[R. McDonald]

I agree with the above 3 posts. I have been using the Versalab Washer (16x20) for over a year now and it is great. It's not as impressive looking as some of the others but you can't beat the value. I have modified mine by drilling holes for acrylic rods so that I can use it for sheet film and smaller prints without having to go fishing every time. I should note that I do own a Machine Shop and it would be tough for me to put together all the materials and then add on just a few bucks an hour for labor and come out ahead of their price. And they are not joking about it being allmost indestructible. I would also add that you should buy the smallest one you will need as this is a heavy beast when in service, unless you do 20x24 prints every day.

Good Luck,

Mac