How to reload a Fuji quickchange cartidge

**NG Sai-kit** · 3-Mar-2002, 22:39

Hi guys, I've problem to open the quickchange cartidge, how can I reset the coun ter? I'm the first time to load 45 films, I use roll film for my 45 gear in the past, and I would like to try 45, so where should the film node located? Pls. lead me the way it should be. Thanks.

**Adam Gibbs** · 4-Mar-2002, 01:04

Ng Sai Kit, if you are talking about the 8 sheet Fuji Quickchange there is some good info in a previous thread at http://hv.greenspun.com/bboard/q-and-a-fetch-msg.tcl?msg_id=006LET should answer all your questions. I have been using one for a few weeks now, great product. Be careful in cold weather though the septums can stick a bit.

**tim atherton** · 4-Mar-2002, 14:20

http://www.robertwhite.co.uk/accessories.htm#LabelQuickchange

I had a quick look at one - as i recall, you just reset it with a small screwdriver as mentioned her

tim

**John Hennessy** · 5-Mar-2002, 01:06

To open the cartridge, I press down on the two tiny sliders on the end with the first and fourth fingers of my left hand while pushing off the end with my right thumb. To reset the counter I use my finger nail or any pointed object.

**Willem Numan** · 29-Jan-2006, 13:58

Just saw this thread. A bit old... but good info is always nice.
So for a real good explanation on how to use the Quickchange have a look at:
http://www.f32.net/Services/Equipment/Accessories/quickchange.html