Have a 8x10 Kodak 2-D this is missing a knob on the front rise and fall control. Do you know where I can find one or who would make one for me?
Here are some photos:
Have a 8x10 Kodak 2-D this is missing a knob on the front rise and fall control. Do you know where I can find one or who would make one for me?
Here are some photos:
Richard Ritter?
If you're interested I could make you one, I had to reproduce the entire front rise
mechanism for my 5X7 2D restoration.
Any local machine shop.
Like Jim C, I could make you one. Either send me one to copy or provide a good engineering sketch. I machine brass & aluminum and some mild steel. It like LF is a hobby but unlike LF I'm good at it. Anyone want to buy a Wisner 4x5 pocket expedition?
Jim Ewins
Jay,
If you find some one to make you one, have them make two. I need the exact same knob on my 2D.
Wayne
Gordon, you are correct. $50 to 100 is very low for custom machining of any kind. My shop rate is $85/95 per hour. My overhead is about $65 an hour. I usually do camera work for friends or LF Forum members at $50 an hour, or less, but I am performing that work myself and happy to be helping someone out. Most shops are over $100 an hour now. My auto mechanic is at $110 !!
If you're interested to see what my day job is...
http://machinearts.com
Jeffrey - some of the examples on your website are exquisite!
Wayne - I'll see if we can get a few made.
Does anyone know if this rise and fall system was standard (or a factory option) on the Kodak 2-D or if it is an after market modification?
My 2-D 8x10 has the type of rise/fall mechanism that Jim C has (on his camera, that is..). The knob has a short axle, and acts on a rack on the rear side of the front frame.
Svein
Bookmarks