Can someone please tell me what size hole I would need to bore for the flange of an Alphax or Betax #3 tens flange. Want the flange to fall into a Sinar board. Thanks so much. At work and cannot get this without help in time to do the job.
Can someone please tell me what size hole I would need to bore for the flange of an Alphax or Betax #3 tens flange. Want the flange to fall into a Sinar board. Thanks so much. At work and cannot get this without help in time to do the job.
He is no fool who gives what he cannot keep..to gain that which he cannot lose. Jim Elliot, 1949
http://tonopahpictures.0catch.com
Just measured the OD of a flange on a Betax #3 and got ~53mm. So a 54mm or 55mm hole should work.Originally Posted by Jim Galli
-Darren
Thanks Darren. Got in a hurry and bored it to 2 1/4" / 57mm after looking at Steve Grimes site (1.98" thread) so should be just right. Again thanks.
He is no fool who gives what he cannot keep..to gain that which he cannot lose. Jim Elliot, 1949
http://tonopahpictures.0catch.com
Posting Permissions
Reply With Quote
Bookmarks