Originally Posted by
BetterSense
I have a speed graphic with a kalart rangefinder on the side. It was all taken apart so I put it back so the lever fits behind that knob on the rail.
Now the image moves when I move the rail back and forth. I have a 127mm tominon lens; I'm not sure if the rangefinder is going to match the lens at all focal ranges, but I adjusted the infinity stops so the ground glass shows focus at infinity and then adjusted the rangefinder so that the moving image is the same height as the static image when the groundglass shows focus at about ten feet. This is easy to adjust with the screw on the lower prism. However, the moving image is displaced quite a bit in the horizontal direction. I couldn't figure out what to adjust to get horizontal agreement.
Bookmarks