Good one, and good one Shane and Miguel too-
That's ok MrTorture, blame me, I'm used to it-
Would be great if 3d printing produced opaque parts, even better if it was ir opaque too-
maybe something to investigate further-
but the Al/epoxy should sort everything out-
I didn't find the helical to be difficult to reassemble-
though I took great care to centre the lens.
I once had a 47mm f/8 Komura, though I didn't measure it at the time-
but I expect it might have been a tight fit too-
I know the SA XL is too big...
Let's see some more of these, never tire of them...
Bookmarks