TMY, Pyrocat HD and scanning

[eddie]

semi stand develop is used with higher dilutions. if you are using 1:1:100 i would have to say you are over developing.

why not go out and shoot another roll. develop it for 10 min at 68 degrees at 1:1:100 agitate "normally" (first 45 seconds continuous and then every 30-60 seconds after that.) scan and get back with us.

if you really want to try semi stand try 1:1:250 for 18-20 min. scan and get back with us.

eddie

[Ken Lee]

No light table? Use a window and a sheet of paper.

Precisely ! Or a computer monitor and an empty white document.

Also, is there excessive grain on the 4x5 sheets ? They were developed differently, and are from a different batch of film at the factory.

[Matus Kalisky]

Tank you. As it was suggested - I will do my homework and try different developing procedures and finaly post here. Though it may take some time as I will be travelling/busy onver next few weeks. I guess I will start with "normal" developing with times suggested by photoformulary (thanks Ken - I had that before but lost it).

thanks again