Good glue for foamcore

[Ron Marshall]

I want to glue some of my foamcore sheets back to back. What is a good glue for this? I won't need to reposition or remove it.

[bwaysteve]

I use a double sided tape gun.Try Light Impressions

[Vaughn]

How big?

If not too big, how about rubber cement? Coat both sides, let them almost dry, then put them together. Should be permanent.

Vaughn

[Greg Lockrey]

I use 3M 3/4" double sided mounting tape. A good trick is to mount so that curve sides are opposite face to face that way they pull each other flat.

[Ben Chase]

Gorilla Glue?

[Randy H]

3M super 77 spray. does not attack the foam, will be there forever. repositional for a short period of time. easy to find and use. once pressed together firmy, aint gone nowheres forever. I also use this for bellows. good stuffs.

[vonstauren]

Contact cement does the job but the foam needs to be aerated for a day or so to lose the vapors.

[aduncanson]

I once met a man who built finely detailed full size mock-ups of helicopter cockpits out of foamcore for Boeing. He was an artist. He used hot melt glue almost exclusively. When I tried it, it was a mess. but I was impatient.

[jnantz]

you might also try polyvinyl acetate ( pva ) sold in
all sorts of art supply stores. its made for gluing paper.

[MIke Sherck]

I built several pinhole cameras out of foam board and Gorilla Glue. The foam board gave up before the glue joints did. Good luck!

Mike