Results 1 to 2 of 2

Thread: Graphic View Camera

  1. #1

    Graphic View Camera

    I have just purchased the Graphic View I, looks to be in good shape. However when I use the front riser rack and pinion assembley, especially when th e bellows are "tight" it doesn't want to stay in place (creeps down). Is there a way to tighten it? Thanks, Lawrence

  2. #2

    Graphic View Camera

    Lawrence: Slide the shaft with gear to raise the board to the right. It should lock the board in place. Move back to the left to release. Directions are from back of camera.

    Regards,

Similar Threads

  1. Graphic View I , Graphic View II, Grover 4x5
    By Les Alvis in forum Cameras & Camera Accessories
    Replies: 7
    Last Post: 9-Nov-2005, 12:05
  2. Springs for Graphic View I 4x5 camera film back
    By peter lui in forum Cameras & Camera Accessories
    Replies: 1
    Last Post: 29-Aug-2005, 13:18
  3. Graphic View Camera
    By Rodrigo Malta in forum Cameras & Camera Accessories
    Replies: 4
    Last Post: 13-Nov-2001, 20:58
  4. graphic view II
    By Robert Choi in forum Cameras & Camera Accessories
    Replies: 2
    Last Post: 9-Nov-1998, 10:24
  5. Graphic View II
    By George_9 in forum Cameras & Camera Accessories
    Replies: 1
    Last Post: 7-Oct-1997, 04:40

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •