I'm in the process of putting back together a speed graphic that I picked up and resuscitated (well, almost!). I have a question about the bar that comes from the kalart rangefinder, that goes from the shaft that comes out of the RF into the speed body to the sliding assembly. How do I put it back? I tried bu the RF was way out of alignment, not starting or ending in nearly the right place? Does it matter where I start it, (ie, where the lens is racked when I place the bar against the stop and tighten the top. The kalart was set and accurate before..)
I checked graflex.org but that seems to only cover realigning already-assembled Kalarts.
Help!
doug
Bookmarks