Results 1 to 3 of 3

Thread: QR plate question

  1. #1

    Join Date
    Oct 2006
    Location
    Long Island, NY
    Posts
    51

    QR plate question

    I just got a used BOGEN 3047 head with QR plate from eBay ($40). Problem is the threads on the QR plate bolt are bent. I have an Omega 45D. Can I get the the correct bolts (I think they are 3/8" and 1/4") from the Home Depot - or should I ask for a replacement QR plate? Thanks.
    Ken

    P.S. Merry Christmas!
    Last edited by Ken Grooms; 25-Dec-2006 at 20:52.

  2. #2
    reellis67's Avatar
    Join Date
    May 2006
    Location
    Florida
    Posts
    172

    Re: QR plate question

    Replacement plates run about $25, or you could replace the bolt with a generic bolt, but the replacement bolt will not be as easy to use as the original. I'm sure it would work, it will just be a bit harder on your finger tips than the factor bolt.

    The threads are either 1/4" or 3/8", so get which ever fits your camera either way you go. For my 8x10 camera, I've attached the plate to the camera base with additional screws using the holes in the release plate to add stability (and piece of mind). If you want to use multiple cameras with the head, pick up a few extra release plates and keep them one the cameras you wish to use on that head.

    - Randy

  3. #3

    Join Date
    Mar 2006
    Location
    Sullivan, IL
    Posts
    763

    Re: QR plate question

    I have the same head and camera, what I did on mine, was remove the bolt and countersink the hole for a 3/8" countersunk screw (1/4" is just too small to support the camera well), apply a drop of removable locktite, and attache the plate to the camera. Using a countersunkhead screw allows it to sit on the shelf flat when not in use. (though in all fairness, I have an extra rail clamp that I use with my gitzo when I take the camera out)

    erie

Similar Threads

  1. Plate Camera Question
    By ViewCameraNut in forum Cameras & Camera Accessories
    Replies: 16
    Last Post: 13-Jul-2006, 12:36
  2. Wet Plate Collodion question
    By Pete Caluori in forum Darkroom: Film, Processing & Printing
    Replies: 3
    Last Post: 16-May-2006, 20:16
  3. Replies: 23
    Last Post: 18-Nov-2005, 04:00
  4. Linhof Master Technika & Quick Release Plate
    By Gary Goodman in forum Gear
    Replies: 6
    Last Post: 22-Aug-2005, 18:35
  5. Installing a packard shutter
    By Mark_3632 in forum Lenses & Lens Accessories
    Replies: 11
    Last Post: 27-Sep-2004, 08:35

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •